Services. S&W M&P Trigger Job. Standard Trigger job- $ plus return shipping. Smoothes out and reduces pull weight to as low as pounds on the. I am shooting IDPA and steels using M&P 9mm Pro. Is there any preference between an Apex Trigger and a Dan Burwell job?. I discovered the link to Dan Burwell’s website while searching through the archives here. Following his thorough and detailed instructions.
|Published (Last):||12 May 2010|
|PDF File Size:||12.85 Mb|
|ePub File Size:||20.50 Mb|
|Price:||Free* [*Free Regsitration Required]|
Page 1 of 3. Trigget can report that it did make a positive difference in the trigger, not Apex positive, but better than stock. I’ve written this before in different words Pm me if you need help. Thanks for the link. They’re making buwell sear you just can drop-in and leave your factory one alone, the angles from a photo on the mp-pistol.
No one burqell a 5″ barrel and that slide mass when using a red dot in competition and to make minor Power Factor. And if both of them work well you can do mine! It’s magnetized so if yours falls out just position it back over it’s little spring with tweezers and it’ll stay put until you re-install the sear. Originally Posted by PaPow You sound like your inexperienced to me.
I just looked at their site and looks like they’re already sold out! Its already researched, tried and tested true and its quick and easy.
It’s not mentioned in Mr.
Originally Posted jjob PaPow. Reduces reset and over travel. I didn’t use a stone, I used very fine auto sandpaper, grit I think. Smoothes out and reduces pull weight to as low as 3. Share this post Link to post Share on other sites. I’m happy with what I have at the moment. There are other makers whose handguns I would check out if I was doing it all over, but I’m not.
My compact is plenty good for what I expect of it. By using this site, you agree to the following. Originally Posted by lthrnck03 I did the Burwell trigger job on my own. Just watch out for the itty-bitty plunger type thingy that is under the sear in the sear assembly block Thanks gurwell the link!
M&P Trigger Job – Burwell? –
Sign up for a new account in our community. I’d be hesitant to do it. Burwell’s directions because I bet for most it stays put, but it’s small, I mean REAL small, and I almost lost mine when it dropped out I suspect dzn isn’t doing them anymore.
Question on Apex Trigger. This will save time and effort. Makes significant improvement over stock trigger. This removes as much of the pre-travel as possible while maintaining all the safeties.
Want to do the Burwell trigger job
I think it’d be fantastic. Also, I googled 3M wheel. I did my first Sigma and it came out ok, So I guess I will try this. Home Forums Classifieds Site Sponsors. Originally Posted by BrianK. Footer title This content can be configured within your theme settings in your ACP.
Posted December 24, edited. I did the Burwell trigger job on my own.